Fountaine Pajot Lavezzi

Work Done in last 18 months.

Mast & Rigging:

• Remove, polish and replace mast hardware. $2,500.00  June 2023 Annapolis Rigging
• Fabricate new standing rigging and cordage  $15,761.00 June 2023 Annapolis Rigging
• Installed new winches, clutches and swivel blocks $7,315.00 January 2024 Annapolis Rigging
• Install new jib, sheet cars and tracks, install main halyard  $3,820.00

Painting

• Bottom painting $2,400.00 October 2024 Port Annapolis Marina 
• Paint rudders, sail drives and props $1,142.00 Port Annapolis Marina

Rudders

• Replace rudders and rudder bearings $16,309.00

Engine Work

• Replaced port and starboard heat exchangers
• Replaced Fuel Shutoffs for Both engines  $3,655.00 Port Annapolis Marina
• Replace both engine Control Panels $809.00 Port Annapolis Marina
• Replace Port Water Pump  $1,105.00 Port Annapolis Marina
• Replace Starboard Engine Muffler $651.00 Port Annapolis Marina

Saildrives

• Repair and service Port Saildrive  $5,237.00 Port Annapolis Marina
• Replace Starboard Saildrive $14,771.00 Port Annapolis Marina
• Service folding props and replace zincs $3,412.00 Port Annapolis 

Sails

• New Head & Mains Sails $13,000.00 Precision Sails
• Installation and rigging $2,900.00Port Annapolis Marina

Electrical Work

• Install VHF Antennas, steaming lights and deck lights $7,087.00 Annapolis Rigging
• Install Radar , Raymarine displays, and wind instruments $9,540.00 Electronic Marine Services
• Replace Port AC PanelBox $753.00 Port Annapolis Marina
• Replace and repair Invertor Warranty) $1845.00
• Replace 120VAC GFCI outlet in starboard aft cabin $168.00 Port Annapolis Marina

Miscellaneous

• Replace all through hulls  $8,245.00 Port Annapolis Marina
• Replace Anchor Roller Plate $4,049.00 Port Annapolis Marina
• Reseal Port Hull Windows $1,413.00 Port Annapolis Marina
• Service Windlass $133.00 Port Annapolis Marina
• Clean and service starboard head sink & drain Port Annapolis Marina                                    ($141,760.00)

NEW VOLVO D 1-30'S INSTALLED AND NEW CONTROLS AND GAUGES!!  5/1 /25

Additional work

• Resealed windows and replaced hatches as needed (2 hatches replaced).
• Installed Harken electric winch (46.2 ST E) with foot control pedals at the helm station.
• Installed Spinlock XTS Rope Clutch in front of the helm station to run the main sail line.
• Replaced liferaft with Viking 6px Liferaft
• Rebuilt solar panel wing
• Installed 6 Sun Power semi flexible solar panels solar panels (can generate 1 kilowatt of power) with Victron controls
• Installed 3 LifeBlue lithium batteries and 2 new AGM starter batteries (600 amp hours)
• Installed Victron 120 amp charger/3,000 watt inverter (all electrical controllers are also Victron)
• Rewired everything in the engine rooms
• Ran 110 electrical lines to the port-side of the boat (installed electrical outlet in the aft port cabin)
• Installed new 12-volt fans in all 4 bedrooms and the kitchen
• New VHF Radio, with removable handheld mic that can be plugged into the helm station
• Installed new captain’s bench at the helm station (with a reversable back)
• Installed Pirate Lights system (2 LED lights on the back of the boat and an alarm system)
• Installed LED light over the outside dining area.
• Replumbed the kitchen sink
• Installed Forespar Purewater+All-in-one Water filtration system in the kitchen sink area
• BEP Marine 81-163-0001 Distribution Buss bar
• Installed new water heater (relocated beneath aft port cabin bed)
• Installed D60 fresh water maker
• Installed Scandvik Shower – Transom Euro Trigger with Mixer hot water deck shower
• Braced the hard-top canopy above the galley entry way and custom built
• Raymarine hybrid-touch electronics upgrade (includes chart plotter, autopilot, wind instrument, wind-finder, surface-over-ground speed indicator, and depth instruments, including the 4-on-1 sensor/transducer) 
• Recovered all interior and exterior cushions
• Replaced trampoline
• Installed Jebsco electric flush toilets
• Installed Fusion MS-R870NSX stereo and 4 speakers throughout the main cabin
• New Sarca anchor and 250 feet of anchor chain
• Installed anchor control switch to the helm station
• Installed USB charging port at the helm station
• Refurbished and cleaned the anchor winch
• Installed red/green navigation light on the front spar area, along with a white navigation light on the solar wing
• Installed the sail spar.
• Installed new fresh water pump (AquaSure 5 gallon per minute)
• Replaced the lazy jacks.
• New Braided anchor bridle and mooring ball bridle
• Added USB charging stations on the control panel (in the galley)
• 8 fenders and dock lines included
• Back-up gas powered electric generator HONDA 2200

Disclaimer

The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.