Storebro 430 Baltic

Storebro 430 Baltic 1999. Manufacturing number 3824.
Volvo Penta 73P x 2, Twin disc 5061A approximately 1500 hours. Onan generator 6.5 KWh 665 hours

Work completed in 2025 for the 2026 season

Both gearboxes fully renovated by Trans Auto after an incorrectly performed alignment the previous year. All wear parts replaced. Painted.
Oil coolers for the gearboxes renovated and cleaned, pressure tested, and painted.
In connection with the above work, a number of gaskets were also replaced, which became easier to access when the gearboxes were removed.
Replacement of all engine mounts
EDC wiring updated, connectors replaced with soldered connections. Installation of SPM box. Updated to the latest VP bulletin and calibrated.
New starting batteries 2 x CCA 1300
New service batteries 2 x 170AH
New battery wiring
New vent hose to the port fuel tank
Re-caulking of the teak deck where something had released
Presto hydraulic dinghy lift serviced with new sliding bearings.
Engines and generator serviced with new oil, filters, impellers, and anodes. Glycol-cooled.
All anodes on shafts, trim tabs, bow, and stern propellers replaced.
Polished
Stored in a heated hall in Bohus Malmön
Service work and materials for the above have amounted to 724,000 SEK.

History
It was exhibited at Boot in Düsseldorf in 2000, the intention was for it to be shipped to Helsinki and the Finnish dealer. This probably did not happen for somewhat unclear reasons. It was sold in 2001 to a Swedish customer, in 2004 the boat was sold to the next Swedish customer, at that time the boat had 380 engine hours.
The boat was at Vindö Marin in their heated halls and they let it be launched for 3 weeks while the owner made long trips. After these three weeks, it was lifted back into the heated halls for a full overhaul.
When you see Martina's dark mahogany interior, it is hard to believe that she is 25 years old. The reason is of course that she has had the privilege of being stored indoors for long periods.
In 2018, the current owner buys the boat, which is renamed Martina V. At the time of purchase, it had 899 hours. It was stored in a climate-controlled outdoor tent in 2018-19, then until 2023 in heated halls in Mälaren and in 2024 in a heated hall in Bohus Malmön.

Exterior
The hull is in very good condition, no damage and high-gloss gelcoat.
All wooden decals painted with 13 layers of 2-component paint and 2 layers of automotive clear coat by Roger Berg, Lackdesign Vallhamn, 2023.
Full teak deck in very good condition, original thickness.
Newer custom-made sunshades in black mesh.*
Really thick dark plexiglass around the aft deck and flybridge.

Flybridge
Modernized instrument panel in black with recessed Simrad NSS Evo03 screen for navigation and two Simrad screens showing engine data. Folding steering wheel. Controls for bow and stern propeller. Mente Marine trim tab automation.
Hydraulic folding of the gullwing.
Newer cushions and textiles.
Oil-damped driver and passenger seats
Two newer flybridge covers, one larger that attaches to the gullwing and one smaller sportier. Both roll up easily and are stored during travel in a case mounted on the console.
Teak table and two folding chairs are stored under the flybridge console.
Teak deck

Aft deck
Powerful electric winches x 2 facilitate mooring.
New deck hatch in low profile with teak lid.
New larger teak table, original table and chairs all with covers included.
Mahogany railing, mounting backs for table and chairs, flagpole and boat hooks painted with 13 layers of 2-component paint and 3 layers of automotive clear coat, 2023.
Newly made wider bimini with the attachment rail on the outside for more space and rain drops outside the aft deck.
Two robust teak boxes for storing lines.

Swim platform
Presto XL500 hydraulic lift for rib or scooter. Lifts 500kg, meaning you can stay seated with shopping bags and be lifted up. Controlled with a remote.
Shower with hot and cold water.

Dinghy
Arimar rib with 20Hp Yamaha. Electric start, steering console. Very few hours. Extremely seaworthy rib. Complete with cover.

Foredeck
Extra shore power connection, Filax 2 transfer switch installed for safe use.

Salon/helm
Newer Simrad NSS Evo03 hidden mounted under the chart table.
Simrad 10” color radar
Gobius port fuel tank gauge and septic gauge hidden installation under the chart table.
Mente Marine trim tab automation.
Newer Fusion radio with NMEA.
Newer Victron isolation transformer
Newer 24” LED flat-screen TV with DVD player.
Ice maker
Newer carpet
Sliding door to the salon has nylon bearings and is therefore a bit stiff. If you don't like that, there is a new sheet rail with a cart on board for replacement.

Kitchen
Newer oven

VIP cabin
Newer seawater pump
Large set of spare filters, pumps, etc. in the bilge.

Master cabin
Hidden installation of Watermaker Afflux Baltic, fully automatic for the Baltic Sea. Recently serviced by Afflux and needs to be commissioned again before use.
Older flat-screen TV.
Newer carpet.

System
Existing NMEA and new NMEA 2000 backbone system. Connected to the system is a Yacht Devices engine data sensor so that all engine data available, e.g., RPM, temperature, engine hours, consumption per nm and hour, etc. can be displayed on any screens as well as smartphone, tablet, etc. YD now has sensors for tank gauges to also get tank status on the screen.
Sleipner remote control for controlling bow and stern propeller, prepared for anchor control.

Engine room
Volvo Penta TAMD 73P-EDC x 2, Twin Disc 5061A.
Onan generator 6.5kWh
Eberspächer D5L
Newer powerful LED lighting
Newer Johnson pressure water pump with hydro press.
Newer Isotherm hot water heater
Newer Marco oil change pump
Septic hoses and hull penetrations replaced in 2020.

Service and refurbishment history
Every year, oil and filters have been changed as well as impellers and anodes on both engines and generator. The engines have been flushed with glycol before winter storage.

2018
Polishing
Installation of Presto 500kg dinghy/scooter lift
Installation of AGM battery for Presto and DC/DC charger

2019
Polishing
New bimini aft deck
New cushions flybridge with Sunbrella Silver textile
Large flybridge cover that goes up to the gullwing
Small flybridge cover
Black sunshades in mesh fabric
New instrument panel on flybridge
Simrad Evo 3 NSS 12” plotter
Simrad GO 7” plotter x 2
New NMEA 2000 backbone system throughout the boat, Yacht Devices Engine gateway with several nodes
Victron isolation transformer
Watermaker Afflux Baltic, fully automatic
Replacement of bow thruster relay QL 1200.
Replacement of WC Jabsco silent

2020
Replacement of shaft seals
Testing of high-pressure pumps by El & Diesel. No faults
Testing and action on injectors by El & Diesel.
Simrad Evo 3 NSS 9” installation helm
Polishing
Installation of shore power outlet also in the bow including digital switch
Replacement of WC Jabsco silent
Replacement of septic hoses
Replacement of septic penetration
New Jabsco septic pump (plus one more new as a spare)
Johnson aqua jet flowmaster pump automatic
New hot water heater

2021
Polishing
Replacement of port generator
Installation of exhaust temperature sensor
Installation of Sleipner remote control for stern, bow, and fore and aft anchor.

2022
Polishing
Marco UP6 oil change pump installed
Deck hatch aft deck replaced with low profile with teak lid.
New darker decorative decals
New darker snob line decal

2023
Polishing
All external wood painted with 13 layers of 2-component plus 2 layers of automotive clear coat.
Installation of EDC VP bulletin 37-1 6 03
Replacement of potentiometers
Replacement of older EDC wiring to splice-free wiring
Replacement of worn oil hoses on both machines
Service of Afflux Baltic Watermaker (not commissioned after service)
New teak table aft deck

2024
New battery for generator
Polishing
Bottom painting